Changes

Line 23: Line 23:     
== plan B ==
 
== plan B ==
essentially, you'll be progressing 2,1,3 from plan A
+
essentially, you'll be progressing 2,1,3 from plan A.
   −
1) cut just behind the rear heat shield mount
+
1) cut just behind the rear heat shield mount. the placement is not very critical.
   −
2) measure the distance to the plate inside
+
2) measure the distance to the plate inside.
   −
3) add 3mm to that measurement and cut again
+
3) add 3mm to that measurement and cut again. this cut is critical. you only have about 4mm between the plate and the beginning of the rear cone inside the pipe (refer to first pic)
    
4) weld it back together! make sure that hole on the rear is rotated towards the ground.
 
4) weld it back together! make sure that hole on the rear is rotated towards the ground.