Changes

No change in size ,  19:26, 24 August 2014
Line 25: Line 25:  
#Cover the new piston with 2-stroke oil, as well as the walls of the kit. Line up the ring gap with the locating pin. While compressing the ring(s) with your fingers, slide the kit over the piston. You will need nimble fingers to compress the rings on the piston while sliding it into the skirt. Make sure everything is straight. Once you get the rings in, it should slide on easily. <br/>[[Image:009.jpg|500px|Ring gap lined up with locating pin]]{{clr}}[[Image:010.jpg|500px|Ring gap lined up with locating pin and compressed]]{{clr}} [[Image:008.jpg|500px|Your arrow is still pointing down]]{{clr}}[[Image:011.jpg|500px|Compress the ring(s) while you slide the cylinder on]]{{clr}}[[Image:012.jpg|500px|Yay! The cylinder is on.]]<br/>{{clr}}
 
#Cover the new piston with 2-stroke oil, as well as the walls of the kit. Line up the ring gap with the locating pin. While compressing the ring(s) with your fingers, slide the kit over the piston. You will need nimble fingers to compress the rings on the piston while sliding it into the skirt. Make sure everything is straight. Once you get the rings in, it should slide on easily. <br/>[[Image:009.jpg|500px|Ring gap lined up with locating pin]]{{clr}}[[Image:010.jpg|500px|Ring gap lined up with locating pin and compressed]]{{clr}} [[Image:008.jpg|500px|Your arrow is still pointing down]]{{clr}}[[Image:011.jpg|500px|Compress the ring(s) while you slide the cylinder on]]{{clr}}[[Image:012.jpg|500px|Yay! The cylinder is on.]]<br/>{{clr}}
 
#Add [[head gasket]] if you are planning to run one. <br/>[[Image:013.jpg|500px|Add the head gasket.]]<br/>{{clr}}
 
#Add [[head gasket]] if you are planning to run one. <br/>[[Image:013.jpg|500px|Add the head gasket.]]<br/>{{clr}}
#Place head back on and re-fit the head screws. VERY carefully tighten to the specs listed in the manual. (Check your manual for the correct torque specs). [[Image:014.jpg|500px|Add the head]]{{clr}}[[Image:016.jpg|500px|Tighten the nuts in an X pattern]]<br/>{{clr}}
+
#Place head back on and re-fit the head screws. VERY carefully tighten to the specs listed in the manual. (Check your manual for the correct torque specs).
 +
[[Image:014.jpg|500px|Add the head]]{{clr}}[[Image:016.jpg|500px|Tighten the nuts in an X pattern]]<br/>{{clr}}
 
#You should probably use a new exhaust gasket; re-fit exhaust the way it came off.
 
#You should probably use a new exhaust gasket; re-fit exhaust the way it came off.
 
#Re-fit carburetor with cables, airbox, gas line. I usually put in a larger [[jet]] here, because you know you will need to. Might as well upjet once before the carb goes back on.
 
#Re-fit carburetor with cables, airbox, gas line. I usually put in a larger [[jet]] here, because you know you will need to. Might as well upjet once before the carb goes back on.
2

edits