Special:MobileDiff/22053

no edit summary
Line 6: Line 6:     
2) if you masterfully cut that rear section off, then cut on the other side of the ridge, like 3mm over. the cat converter (on the bottom) was removed from between the center peice and the right piece (both on the top row).  Ignore that leftmost cut, it was erroneous.
 
2) if you masterfully cut that rear section off, then cut on the other side of the ridge, like 3mm over. the cat converter (on the bottom) was removed from between the center peice and the right piece (both on the top row).  Ignore that leftmost cut, it was erroneous.
 +
 
[[Image:2 20141124 200935544.jpg]]
 
[[Image:2 20141124 200935544.jpg]]
    
3) weld it back together! make sure that hole on the rear is rotated towards the ground.
 
3) weld it back together! make sure that hole on the rear is rotated towards the ground.
 +
 
[[Image:333 20141124 200327557.jpg]]
 
[[Image:333 20141124 200327557.jpg]]