This page is a collection of stock wiring diagrams for a variety of Puch mopeds.
This will work or be close enough for just about any Maxi, Newport, Pinto, Swinger, Free Spirit, Magnum, Murray, etc. For additional information about and versions of this diagram, please see Puch wiring.
Early Maxi (1976-77)
Early Early Puch 1973 2 coil (3-wire)
A) Light out B) Dim light C) Full beam D) Buzzer (horn) E) Short button (kill switch)
1) Headlamp 2) Multifunction control 3) Magneto 4) Spark plug 5) Tail lamp 6) Buzzer (horn)
Schwarz- Black, Gelb- Yellow, Grau- Grey, Weiss- white
Horn wire from 'H' in the multifunction control to the horn is magenta
IMPORTANT NOTE: The green/red (not shown on the diagram which is otherwise accurate) and the yellow wires leaving the magneto should be twisted together and put into the terminal block together. The wire continues as yellow only. The other wire colours meeting at the terminal block are black to black and grey to grey.
1976 Puch Maxi/5-wire Bosch Magneto
This would probably also be applicable, or mostly applicable, to Maxis, Swingers, Pintos, Free Spirits, and most other Puch mopeds.