Difference between revisions of "Modify stock a55 exhaust"

From Moped Wiki
Jump to: navigation, search
Line 2: Line 2:
  
 
cut on the rear edge of the ridge, stay very close to save the rear cone thats hidden inside the pipe. you can see the weld line on the peice in my hand and the rear heat shield mount on the pipe.
 
cut on the rear edge of the ridge, stay very close to save the rear cone thats hidden inside the pipe. you can see the weld line on the peice in my hand and the rear heat shield mount on the pipe.
 +
 
[[Image:1 20141124 194139300.jpg]]
 
[[Image:1 20141124 194139300.jpg]]
  

Revision as of 22:49, 24 November 2014

starting from the rear of the pipe, there should be a ridge between the first weld line and the first heat shield mount. you need to cut the pipe on both sides of the ridge to remove that clogged cat converter.

cut on the rear edge of the ridge, stay very close to save the rear cone thats hidden inside the pipe. you can see the weld line on the peice in my hand and the rear heat shield mount on the pipe.

1 20141124 194139300.jpg

if you masterfully cut that rear section off, then cut on the other side of the ridge, like 3mm over. the cat converter (on the bottom) was removed from between the center peice and the right piece (both on the top row). Ignore that leftmost cut, it was erroneous. 2 20141124 200935544.jpg


333 20141124 200327557.jpg