Clutch

From Moped Wiki
Revision as of 01:21, 3 July 2008 by Ar71c40k3 (talk | contribs)
Jump to: navigation, search

The clutch is a mechanism which can engages and disengages, and is used for transmitting rotation. When the clutch is engaged, movement is transmitted through the clutch from the crankshaft to the clutch bell, clutch housing, or clutch drum. When the clutch is disengaged, movement is not transmitted through the clutch, and the crank is able to spin freely without load. A disengaged clutch allows the engine to remain running while the moped is at a stop.

There are several kinds of clutches found on mopeds, including variator clutches, disc clutches, and centrifugal clutches.

Centrifugal Clutches

An aftermarket 3-shoe centrifugal clutch for the e50 engine. The stock e50 clutch typically has only 2 shoes.

The centrifugal clutch is fairly common, and is found on the Puch E50 engine. In a centrifugal clutch, clutch shoes are held close to the crankshaft by springs, away from the clutch bell. As the crankshaft spins, its motion is directly transferred to the clutch shoes, which spin inside of the clutch housing, but without touching it. As the RPMs increase, and the rotation becomes more and more rapid, the weight of the shoes, along with centrifugal force begins to push the shoes away from the crankshaft, towards the clutch housing. Eventually, the clutch shoes begin to touch the clutch housing, and cause it to rotate as well. However, initially, this light contact will not cause the clutch housing to rotate at the same rate as the crankshaft and clutch shoes. This intermediate stage of clutch engagement is called "clutch slip." When centrifugal force pushes the shoes out far enough that they contact the clutch housing with sufficient friction to cause it to rotate at the same rate as the crankshaft, the clutch has engaged fully.

In the Puch E50 engine, part of the clutch housing is toothed, and these teeth mesh with a final drive gear, which is located on the same shaft as the front sprocket. The number of teeth on the clutch housing and on the final drive gear determines the "internal gearing" of the Puch E50 engine.

However, if the RPMs drop to a point where centrifugal force can no longer hold the shoes engaged against the clutch housing, the springs will push the shoes towards the crankshaft again, and the clutch will disengage to allow the engine to idle.

Disc Clutches

This section is a stub.
You can help the Moped Wiki by expanding it.

Variator Clutches

This section is a stub.
You can help the Moped Wiki by expanding it.

Clutch Parts

-Clutch bell, drum, or housing

-Clutch shoes

-Clutch plate

-springs

See Also

Clutch tuning

Tomos A35 clutch repair