Results 61–90 of 871
I just went outside to try and see if i can the ped started, what do you know it started. But i am afraid to go for a ride because it may die again. any suggestions?
i will have to try to clean the carb
i just topped it off 10 min. before i left
Hi,I was driving my ped to work when the ped had a sudden surge of power then died and will not start up again, i didnt have time to mess around with it cause i needed to get to work asap. My only theory is one of the kill switch wires is frayed and some of the threads are disconnected because the side view mirror keeps getting loose and rubbing up against it, maybe the wires just got disconnected
The junction where the exhaust heat shield starts/where the exhaust pivots it touches the variator pivot bolt ,causing what i believe to be undue friction/vibration that should be dissipated in the rubber bushings. please give me your opinions.
Hi,I'm not sure what it is but i noticed lately at certain points when I ride the performance fluctuates between better and worse. what can be causes for this? maybe oil quality or mixture or dirty carb , fuel flow?I have a Motobecane 50vlxthank you
It was the same way with mine the ped had decals for a grand sport but had a eureka flex vin
sorry i meant to say, i was driving south and he was going north.
I was driving north and I looked to the other side and I saw some one driving a red and black puch top tank? I am thinking to myself he is either got a really fast moped or he got on to the fdr by mistake. Anyone here know who this person is.
I opened one of the brake switches to clean it out and i found there was an extra copper peice that was not connected to a wire? what does that do?
Hi,I got pulled over and was given a ticket for a broken tail light on my moby. I replaced it, but both filaments light up at once so when I pull the brake the brightness doesn't change. what can i do ?thank you,
Hi,I got a ticket for a non working brake light, I replaced it when i got home. The light works, but both the upper and lower filaments light up at the same time without pulling the brake levers. So when i pull the brakes the light remains at a constant brightness. what do i do?thank you
Here is a great web sight with alot of info on passover.<chabad.org>
will this pipe fit a eureka flex? see link belowhttp://www.treatland.tv/motomatic-N8P-p/motomatic-garelli-n8p.htm
thanks for your feed back today i went to a local cycle shop and they sold me a new filter with some new fuel line for 5 dollers the filter has gold in it or something.now all i need to do is to get my jawa to start
well i was wondering if i went to home depot, would the filter be as good as the one you could buy at a cycle shop and if you get it at a cycle shop would it be as good as one you get at a moped shop etc. and can you get one at auto zone?
yes. and rejeting the carb etc.
what should i expect performance wise ?
garelli VIP moped simonini performance exhaust pipe, would this fit a garelli eurka flex ?
like what ped does it fit and performance wise what extra low/ high end etc?
check buy and sell 8 metra kits
i know someone that is moving to italy what do you think it cost to over there? and are you allowed to ship if my friend can get one?
did they charge you a crazy shipping fee ?
is it difficult to install for a beginner? and where did you get it and for how much?
hi,from my understanding a jet allows a certain amount of fuel into the carb, to be mixed with air. the jet has a hole that can be large or smaller to allow less or more fuel. my question is if i just change the jet will my ped go faster ? or is there more to the entire garelli engine that allows a higher mph moped model to go faster?thank u