I'll hit them up. but maybe I should just wait a few weeks lol.
Yeah the nut that rides off the crank to spin the water pump. Treats is out of them for few weeks. Just wanted to see if anyone had the nut and a belt if possible
Mine went on a little trip without me last night. Treats is all out for a few weeks.
Hey guys. Trying to figure out how to covert the AC of my hpi to DC to run a Toyota Prius heater pump on my water cooled hobbit. I'm thinking of using thishttps://www.superbrightleds.com/moreinfo/led-drivers/12v-ac-to-dc-converter-module/1725/But do I have to float the ground on it?Can I just use a diode in line?My lights are all regulated by a trail tech voltage regulator but can the same
I have a Honda hobbit I'm trying to find the jetting for. I'm not an a total noob but no harm in asking around before I start testing.Hobbit with a Metrakit.Race crank, hpi, vforce reeds, and a tm24
Thanks so much man. I'll go check my messages
Great. How much do you want for it?
Just figure I ask around. Got 2 hobbits no titles.
Sean I'll definitely try it out. I've been having problems with the .4s anyway. I have a makeshift air box I made to quite the motor down. And it is the only way I've made enough restriction to not bog off the line. If the air box is off it spuders from not enough vacuum. Will the .3s make it worse?
My setup is a PA5011 stuffy crank, with of course a DR 70cc (no porting), puch/honda head, vm20 mikuni with mlm intake jetted a little rich. .4 reeds. Mlm peoples pipe, dos cycles variator with the rumpus plate, stock cdi.I will take apart the rear pully and clean her up an grease. I never even touched it
Thanks so much man. I'm super glad to finally see a port map for a dr. And I got an ok setup with a big pipe and carb but cant seem to get past 50mph on a good day
Thank you man. I know I'm going to mess some cylinders up for sure. I have junked kstar cylinder to play with also a working pa501.
I'm new and would love to find a starting point to start porting