Not sure what the short "straight" intake is, unless that's the stock one for the Silver Bullet. But the new Airsal cylinder uses this manifold....pic attached. What I've done so far......cut the manifold in half, added a short rubber coupling to extend it and make it a little flexible, broke two fins off the cylinder so the petcock would fit. So now the 15.5 Dellorto fits wi
Cost isn't the question....does that intake fit on the Airsal 70cc kit and does it come out on the left side.....that was the question??
Thanks...guess I should have been clearer, also using a 15.5 Dellorto and there is NO room on the Silver bullet to fit under the tank. Forget the side cover...that's a lost cause. So far have cut the intake in half and lengthened it a bit....with rubber connector for flexibility....now fits up against the engine case with about 2mm of clearance for the pedals.... have to wait and see how
1980 Tomos Silver Bullet....just purchased Airsal 70cc kit for A3 engine. 15mm intake only fits to right side where there is NO clrearance....is there an intake that fits the Airsal port but goes to the left side??Or does the Tomos LX 50 intake fit the Airsal port?Pic http://www.ebay.com/itm/400579226685?_trksid=p2055119.m1438.l2648&ssPageName=STRK%3AMEBIDX%3AIT