Sorry. Starter clutch is what I’m looking for. But I’m always open to snagging whatever other parts I can find.Edit: a whole starter clutch ideally
Looking for pa50 clutch components.
Seems I may have found the leak. Clutch side of the case is dirty with oil. Looks fresh. Gotta pull the clutch off and take a look.
Yeah it does it when the choke is on. I down jetted to idle to 17.5 and the main 145. Those were the suggested jets for a 70cc kit. I’m thinking air leak is the culprit.
I am new to hobbits and tried to get a build goingNew 70cc kit. New stock CDI . New mikuni 20mm round slide carb (down jetted.)It has never been running since the build startedThe problem I’m having is it will not idle for more than a few seconds then it starts to ramp up like it’s at full throttle. Throttle cable has plenty of slack. Slide is all the way down. My guess is air leak? I’ve gone thro
ok so after a good handful of tries. im still without a spark. i was told about a ground wire that should be running out from behind the stator plate??
well im running just a 12v light coil. and an internal coil. i just dont understand whats going on with it
yeah it ran with this set up then it crapped out. its got a full tank of gas. i have put a new plug. cant figure it out tho.
ive tried almost everything i can think of or read about online. still no spark..any other suggestions?
Yeah i replaced the coil. i went with the 12 volt coil. new condenser and went with the internal ignition coil.i have disconnected the kill switch . but still no spark.i guess im going to take it all apart and start over againthanks for the help!
yeah. it was running. it was pretty fast then it just crapped out. dunno.
im thinking i should buy one of those CDI packages. ugh its reeeeally frustrating!!
yeah ive got the the black wire from the point going to the condenser. and i have checked my timing.
its a *pinto 2* with an *e50*
i am a newbie but i am going to try and be as detailed as i can with my post.problem: no sparkset up:e50 casing70cc treat kit3 shoe adjustable clutchinternal ignition coil12 volt light coiluniversal voltage regulatornew condenserboss pipe21mm dellorto race carb (the black one)how i have it wired:*internal coil* has a *white wire* which i have running to the *condenser*(kill switch spliced into wh