Results 1–30 of 802
at the same intersection there was a cop "working" construction detail (by working i mean sitting in his car with the lights on) , i approached him after she pointed the gun at me knocked on the window he cracked it and i told him what happened as she started to drive off his reply was "do you wanna fill out a report or something? its not illegal to own a gun".
Had this lady behind me on a 2 lane road in a car try to hit me and run me off road multiple times to get me out of her way, passed me in a turn driving into other lane of oncoming traffic. few hundred feet later were both at the same stop light, pull up next to her to talk shit for being an asshole and she points a gun at my face. still wish id have thrown my shitty garelli at her car.
Your posts are hard to read, like a transcript of a trump speech it’s all over the place.
Why would you swap the stock hobbit carb for a sha? Those lil 12mm carbs are awesome.
I’ve got a couple Bikes with Runtongs on em run good just don’t overtighten dem screws dat metal soft.
From the first pic I thought it was rubber tubing, I thought how awesome that would look cruising down the street with your long rubber dick intake carb flapping in the breeze.
Yeah Ive fought with it before to get it off. This last time I removed the wheel assembly before loosening the freewheel and placed it freewheel nut side down in a table vice and turned it off using the tire worked great. I’ll try cutting slits in the pads but I’ll get pics of the pads when I do to show the weird wear on it.
Putting new tube on a hobbit rear tire, and I see the break pads have very uneven wear on them. The rear brakes have always sucked on this thing, new pads, cleaning, nothing helps. After I reinstall wheel/tranny on bike and I spin the pedals the chain is tightening and loosening a wee bit. Could the freewheel be bent or damaged or could the uneven wear on the brake pads outside edge be from the sh
I got one with the same wheels, only seen a few.
Here’s my old beast, Sony wm-1. Got it at an estate sale long ago for a whopping $.50. Still works, had that Antonio Carlos jobim tape in there for a decade. Even the old red Sony mdr-1 headphones still work. It’s also got the extra headphone jack for when you and a buddy wanna jam out together.
Looking for a running av7, nothing wild just something to have a running moped.
Got a 5k cap and regular b6hs plug, I'll try the resistor plug and unresisted cap. Everything else is clean and set correctly I believe. The spark is barely visible in the shade.
Got a 5 coil Peugeot that’s getting a pretty weak spark. Replaced points and condenser, unplugged kill switch and wiring harness only wire connected is to coil. Tried different plug boots, plug wires, used a Puch ht coil, still the same. It starts and runs but having tough time tuning it getting lots of carbon build up. Any ideas appreciated.
Cool thanks man thought it was a replacement for the stock springy. My first Peugeot just started messing with the variator reading up on some posts trying to avoid classic pug problems
Wanting to ditch stock spring. The crossbar where the spring mounts on the subframe of my 103 is welded on not removable. If I remove the engine i struggle so damn much with reinstalling it with the spring fighting me and getting those little spacers on between the engine mount and subframe.
one of the treats reviews say the pipe hits the belt/pulley when it variates, did you have any problems with that?
im up here in jacksonville, our scene faded out. fl in general bad place for 2 wheeled devices, especially the big metro areas. wish brent was still around for his yearly ride in inverness.
restep thru it, am i the only one that likes freespirits?
putting new tires on ped, had bike on workbench. just finished tightening up rear axle bolts trying to eyeball rear alignment and tire clearance spun rear wheel went for another spin and instead of spinning tire again i pulled on the chain towards the rear tire stupidly. the tip of my thumb went right between chain and sprocket heard pop noise as a tooth went into my thumb and came out through my
the plate behind the headlight will tell ya what it be
not mine just cruising through estate sales thought someone may be interested. urban express, expresses, qt50s, towny, nice bravo, ratty passport, ct110, and some suzuki nopeds not sure of model.https://www.estatesales.net/AZ/San-Tan-Valley/85143/1875570
https://www.estatesales.net/MO/Salisbury/65281/1732494?highlight=mopedcady grande and hobbit all look in great shape, motocompo italjet and diblasi weird scoot with solex engine plus some other shizzz
might have one, its the one with extra material where it mounts to the frame