Results 1–30 of 42
Jawa Transistor 40 Babetta Moped seat saddle cushion pan #3. As seen from the photos the seat is in very good condition. Seat pouch is attached, but the top is broken. Best offer.Shipped with USPS Parcel Select Ground.
Jawa Seat. $15. + Shipping
Stan Skowronski Wrote:-------------------------------------------------------> Seat from Jawa moped. $25 or best offer, plus shipping.
Seat from Jawa moped. $25. plus shipping.
What are you asking for the oil injector, and the rear crome carrier shipped to 06880? Stan
FS: The seat is off a Jawa Transistor. The seat is in great condition with no rips or tears, and the pan has minimal rust. $25.00 plus actual shipping.
This Seat is off a Jawa Transistor. The seat is in great condition with no rips or tears, and the pan has minimal rust. $25.00 plus actual shipping.
Do you have a working lighting coil for 1977 Garelli Grandsport?
Mark's is to far for me. Any shops in Fairfield County able to look at my Puch? I have tried everything, and it does not want to start!
Do you know anyone near Norwalk, CT that could take a look at my Puch? I have tried everything, and still cannot get it going. Very frustrating!!
The taillight was bad; I replace the taillight bulb, although still no power to the headlight, horn and taillight. Break light works. Could Napa have sold me incorrect wattage for the taillight?
The horn and headlight stopped working yesterday on my 1977 Garelli. The ped kicks over and runs with on problem.I cleaned the contact points on the switch with no luck. I have an ohm meter but no sure what to check. Any ideas?
What is soft seizing, and what is the fix?
My Puch Maxi starts up and runs well for 30-40 minutes, then it starts clanging (sounds like in the cylinder) loses power, bucks, and stalls, After cooling down it start up. I'm tired of pushing it home. Any ideas?
I need help starting my 1980 Puch Maxi. It was running fine until it stalled and now it will not turn over. I have good spark, and after a few pumps the plug is wet. The points look good and I cleaned the carb and the exhaust. I'm thinking the condenser or compression problem. Any ideas or suggestions are appreciated.
Dellorto 14.12. I think the jet is 50.
What size jet should I install. I thing there is 50 in there now.
The hole vent in the gas cap is not there. Its the metal Puch gas cap. I see a vent hole in the top part of the tank and pushed a wire through it to see if it was blocked. Appear good.
I removed the air bubbles from the fuel line only for them to reappear once again.Is it a venting problem? The fuel vent is in the top part of the Puch.
My Puch maxi stalls after 2-3 minutes of riding. I cleaned the carburator and peacock valve and it appears that it is getting gas, although the fuel line is always only half full.I read where it may be the condenser or a clogged exhaust. Any other ideas?
If I change to a smaller size jet, will it effect the performance?
My '77 Garelli gets up to 25-30 mph without the carburator airbox. When I attach the airbox it doesn't get past 20mph. The needle adjustment on the dellorto carb does nothing to effect the performance of the carb. I disassembled and cleaned the carb a number of times. Any suggestions?
My 1977 Garelli Grand Sport has lost its power. The moped would reach 25-30 mpg. Now only 10-15. It always starts on the first pump so I assume that the combustion and points are good. (readjusted and cleaned the points twice). I have cleaned the carburetor a number of times and re-installed a fuel filer in the gas tank. The air mixture jet is not clogged although adjusting the air mixture jet whi
Do you have a garelli lighting coil?
WTB a lighting coil for my 1977 Garelli Grand Sport.
Do you have a lighting coil for a '77 Garelli Grand Sport, and/or a flywheel puller.
Jay. I also have parts for the jawa. E.mail me.
I am interested in the oil injector for my '77 GrandSport. Any pictures, and how much shipped to 06880. Please e-mail to Cranbury25@yahoo.com.