I have a fairing from a Magnum and a NOS windscreen un mounted. The fairing will need to be painted
Ready to bolt on. No lighting coil on these so break out the 2000 lumen bike lights$250 shipping included to lower 48.
New old stock in perfect condition. Best crank for building a Polini Derbi ripper $300 shipping included to lower 48
Probably had the vacuum petcock removed they sucked. You should just take out the front mounting bolt remove throttle cable from top of the carb disconnect decomp cable if you still have one and lower the motor. Makes it easy to get to everything. While you have it down replace intake gaskets while looking at the reeds which might need replacing as long as you’ve gone this far. Also check the plas
Derbi Selettra ignition for Start V. No lights so be home by dark. $225 plus shipping
Looking for a flat reed frame.
Getting back to everyone in order of PM’s
I have a bunch of these that BJ from Handy Bikes tossed in with an order, I also gave a couple of stock Derbi heads and a shit load of moped keys that are sold as a bunch
Sorry WFFF can somebody move me to Buy Sell
Anyone have a set they don’t want
Don’t remember what I even bought this for. Rear sprocket is a 28. No brake or axle $50 plus shipping. tire included
I have floor boards and a front handle bar cover and a speedo
Hey Lance glad you’re back when can we expect another Moped video? I’ve got a whole list of moped related questions it way too long to post here so I’ll just email them to you over the next few months.
3 mm thick. It came from stock aluminum at Home Depot
Anyone who’s tried the VM 18 on their flat reed knows about the dreaded bump on the bottom of the carb rubbing the case and not fitting all the way on to the intake. I’ve ground off the bump and that’s not optimal the just decided to make a spacer.
Looks like a nylon 3D print would work. Send the guru designer at Treatland a case of his favorite beer and maybe he’ll do it