Results 1–14 of 14
Chuck Noble — 18 years ago
need help reassemble carb. not sure what position the throttle goes into carb.Same with choke.Can anyone email me a diagram? Appreciate any help. (Gurtner carb.)
Chuck Noble — 18 years ago
I need to decarbonize the muffler.How do I remove the end cap. I removed the nut but no luck.what is the best way to loosen it.Its probably never been off before.
Chuck Noble — 18 years ago
1980 SACHS carburetor leaking fuel from small hole (factory)located bottom left side where the air filter mounts.I think it might be some type of pressure release.how do I stop it? HELP DON.
Chuck Noble — 19 years ago
Thanks for reply...Columbus here
Chuck Noble — 20 years ago
need side covers and speedometer for 1965 moby
Chuck Noble — 20 years ago
looking for fixer up mopeds in columbus, ohio area
Chuck Noble — 18 years ago
My panther has a low speed miss between 10/15 MPH. are there any adjustments to smooth it out? Its 2003 with about 350 miles.
Chuck Noble — 18 years ago
What and where is the silencer located please?
Chuck Noble — 18 years ago
I got a used 2003 Panther with 285 miles. The muffler has a loud cackling sound.I got the moped from a 15 y/o boy and I'm wondering if he may have done something to make it loud.
Chuck Noble — 18 years ago
Thanks Kelly ..I will check on it.
Chuck Noble — 18 years ago
I live 2 miles from the mall.look forward to see the bikes go by on wednesdays...a really neat parade...I thought about taking my little mini chopper there. (LOL) Bikes are backed for miles getting off of I 71 on to Polaris Parkway.
Chuck Noble — 18 years ago
engine starts fine when cold,but will not start after warm shut down.after it cools down its fine again. appreciate any help.
Chuck Noble — 18 years ago
I Need help on a gurtner carb.(reassemble) position of choke and throttle.
Chuck Noble — 20 years ago
my Tomos runs at high speed on stand,but will not run up enough to change into high gear when off of stand. any ideas PLEASE?