I can’t get the cracking/ 4 stroking/ cutting on the bottom end to stop with this SHA.
Stock get was a 68. Cracked a little on the bottom end but hit almost 48 mph BUT also got way too hot. Screams lean on the top end, I am running the air filter and little stock pod box.
Upjet to 71, temps get a little more under controll, but the bottom end gets worse, i have to like blip it multiple times and give her WOT until she hits the pipe the. She’s golden.
I tried the magic slide from treats, did not seem to do anything for it other than the notorious high idle issue
Is there a way I can modify my own slide to try and get more air in here at the bottom end? I don’t know slide science well and how all that works on a reed motor (any motor really) I know the angle on the bottom and change air velocity? Or some are notched?
My brain just says “throw a 15 phbg on it and call it a day” because I love them and run them on everything and have become pretty good at tuning them. (See my wtb thread if you have one, treats has them but I try to buy used if I can)
I’d like to take this obstacle as a way to learn slide tuning if I can.
Or is there something else y’all have seen before that can cause this?