> Rocco Taco Wrote:
> -------------------------------------------------------
> You could drill that bitch out.
>
> Ken act like he’s never seen a dreamel.
>
> You can probably port that bitch and make good power.
It’s not me doin it and I would charge someone labor plus bits if I couldn’t talking talk them out of it
Time, Dremel, bits, sandpaper rolls and small files is money, plus you have to know what your doin with plated cylinders,
The outside of port is smaller too, such a waste of time and a big mess all over ya and floor for little gain
If you can’t find a good used 2hp top end on buy+sell for 40$ Or a 50cc kit on the Internet for around 50$ then something is wrong