Looking for some advice here, I just installed a ZA50 CDI setup on my Maxi. I currently have the stator dremeled out to where the top screw is under the coil and can barely be tightened. This gets me to 28 degrees of advance. If turn fully counter-clockwise I get 36 degrees of advance. I'm not sure what to do at this point. I found TDC using piston stop method rotating the crank both directions and taking the average of the two marks. I even tried rotating the stator 180 degrees and got similar results. Can I possibly move the pickup and try again? The stator and flywheel came from 1977 mopeds as Treats was out of stock at the time, but the CDI came from Treats as 77 totally botched that end of it.