Okay I got it put together I use some 320 sandpaper and some 400 and finished with some 600 to clean up the ramps a little bit don't want them to shine like a mirror just want to get the highspots off from the Machining it looks good now.
I just made a run with 16X13 rollers @ 16.8 grams I'm real close I'm going to give it a little time to settle in.
It's so nice I don't have that wait forever for it to start to shift out cold it shifts a little sooner on the takeoff which is awesome from a stop and it holds back a little at the top so it's dead nut on in the Power Band good job treats.
And I'm running the Cameo slotted Contra assembly and it is downshifting better with this setup than it did with the t j t plate.
I can be cruising with the RPM's down just like Jay pot said nail the throttle and it drops right into the peak of the powerBan close to it not quite got it tuned perfect yet but very close.
I got to go get some gas damn roommate use my 2 stroke gas for the lawn mower again.
And the lawnmower gas can that I filled last week is empty.
I think he's dumping it in his car cuz I know he was asking me for some gas money the other day.
Going to mix some diesel gas and oil then I'll know for sure when his car is smoking like a freight train.(edited)