> Neil Rayborn Wrote:
> -------------------------------------------------------
> Alex I was really impressed by the fact that you actually cut those
> angled slots I was kind of expecting you to fuck up and break a lot of
> bits trying to cut that hard-ass Steel.
Haha, thanks. But really - yeah, this was a bit more difficult than I initially expected, and some bits, unfortunately, did not make it home after battle :'(
> I think you're really interesting thing to do would be to cut those pin
> guide slots in somewhat of a crescent moon hook cut into the end of the
> angle so that you get a really Snappy downshift and if you're wide open
> throttle you have to back off for a second for it to shift out I think
> that would be the golden set up having up dual angled slot.
Agreed. In fact, I was considering doing this up until I had the first few mm cleared; then I lost appetite for adding complexity to my first shot.
> Alex I have a spare Contra from a cameo and I'm wondering if you
> u wouldn't mind cutting a second steeper angle In it.
Sure, always down for a challenge. Next few months are kinda busy, but I'm happy to ebb away at it in my down time (as long as you're not in a rush).
> We will talk later we both have some time I'm coming real close to
> having a working fore stage system I've got to make a couple of
> justments so I've got cut it in half again and welded move things over
> quarter inch but it's working and it's wicked as hell.
Nice dude.