Okay, so I bought a new belt and instaled it today. For I noticed the wear on the cheeks of the ramp plates looked kinda low. So I did the marke trick where you marke the cheek of the variator, an run it wot till the bike variatws as far as it will. Then check you mark again and see how much has been worn away by the belt. Well mine told me that I had some more to go. I started to examine how the variatioe swings and noticed thatvthe arms that push the outer cheek in don't extend far enough to make the cheeks meet in the middle. See what I'm talking about here.
So I got to thinking... If I maybe glued a spacer in there to make up for the fact that that thrust arms don't force it out all the way I could get that belt to ride all the way to the outer edge. Maybe a sliver of old credit card or something.
Glue them to ither side of t
I don't have the tools to rip it apart in my apartment, so I'll let you know after I tear her open and give that a shot. Any one else notic this? If so how did you remedy it?