Re: e50 clutchbell/clutch clearance
if i remember correctly, they were milled down to the bottom edge of the clip groove, probably could have gone a little tiny bit further, but then you're playing with the clearances on the shoes.
those screws are countersunk too, very importatnt.
much better photos on gabe's blog
|Myyke Nhortonne||02/23/10 08:32PM|
|Gabe Bandit||02/24/10 10:59AM|
|Erin L||02/28/10 02:19AM|
|Graham Motzing||02/25/10 03:16PM|
|Gabe Bandit||02/26/10 10:53AM|
|Myyke Nhortonne||02/26/10 02:33PM|
|Gabe Bandit||02/26/10 05:08PM|
|Gabe Bandit||02/28/10 01:57PM|
|Myyke Nhortonne||03/07/10 03:56PM|