MOPED ARMY

Hmm, I'm matching my intake now... lots of material to take off to get it right. And is the intake sitting flat... ? Hmm, some work to be done here.

I took a lot of material off the top of my intake to get it to fit right. You shouldn't have to do much matching though, as that intake is designed for this kit Mick.

This pictures shows specifically that I knocked down the transfer shoulders considerably and sharpened them, also cleaned up the inside of the transfers a lot, there was all kinds of casting flaws in there. In addition I chopped the piston skirt to it lines up with the transfers. CLEAN UP TIME

SO excited to get this on and running! Here is a pic from before for comparison.

Parma must not have worked hard on casting that kit, those transfers were filled with junk metal!

But shit that is a great case match job there Julian! I'd almost be tempted to weld on extra metal to the crank case and make the transfers on that kit even wider!

They made these for Treat's

yea where you been? ed

sslepping.

I heard that treats hand crafted each one from peanut butter

tequila