Re: Milling intake 'port' in piston

rafter /

Go to branch

Oct 29, 2008 01:55PM

This single post is part of a larger thread. Start from the top or view this post in context.

Yea it works. It improved my top speed and hurt my low end a bit. Go easy on it.

Subject	Written By	Posted
Milling intake 'port' in pistonTopic by: Mars	Mars	10/29/08 10:58AM
Re: Milling intake 'port' in pistonRe: m6onz6a	m6onz6a	10/29/08 11:21AM
Re: Milling intake 'port' in pistonRe: Crackstar X	Crackstar X	10/29/08 11:31AM
Re: Milling intake 'port' in pistonRe: m6onz6a	m6onz6a	10/29/08 01:49PM
Re: Milling intake 'port' in pistonRe: m6onz6a	m6onz6a	10/29/08 01:59PM
Re: Milling intake 'port' in pistonRe: Mars	Mars	10/29/08 11:47AM
Re: Milling intake 'port' in pistonRe: metrakittens	metrakittens	10/29/08 11:30AM
Re: Milling intake 'port' in pistonRe: Nerobro	Nerobro	10/29/08 01:37PM
Re: Milling intake 'port' in pistonRe: SABAT! andDestroy	SABAT! andDestroy	10/29/08 01:52PM
Re: Milling intake 'port' in pistonRe: rafter	rafter	10/29/08 01:55PM
Re: Milling intake 'port' in pistonRe: Moped Game Sally Struthers	Moped Game Sally Struthers	10/29/08 01:57PM
Re: Milling intake 'port' in pistonRe: Moped Game Sally Struthers	Moped Game Sally Struthers	10/29/08 01:58PM
Re: Milling intake 'port' in pistonRe: Flagrant -	Flagrant -	10/29/08 01:58PM
Re: Milling intake 'port' in pistonRe: SABAT! andDestroy	SABAT! andDestroy	10/29/08 02:10PM

Subject

Written By

Posted

10/29/08 10:58AM

10/29/08 11:21AM

10/29/08 11:31AM