> P D Wrote:
> -------------------------------------------------------
> > Richard Eberline Wrote:
>
> > -------------------------------------------------------
>
> > What about checking your ring's end gap in the cylinder's bore. 3
> spots,
>
> > top, middle and bottom.
>
> >
>
> > Any time you replace piston rings, you need to crosshatch the
> cylinder's
>
> > bore.
>
> Good practice ^ .
>
> Considering that some bores are wider at the bottom than top , I'd
> expect those measurements to slightly different . But , not always , if
> we're lucky .
Newbie question here: what's the difference between cross hatching and honing?