OK, I apologize for all the questions, but to me, this is really complicated, and I don't really understand it. Check that, I understand it just enough to be dangerous!
So I will need to open the magneto to either remove or disconnect the faulty condenser. Then while I'm in there, I clean and adjust the points and close it back up. Then I attach the new condenser to the coil mount and attach the condenser lead to the coil primary terminal. Will a newbie like me be able to recognize the primary terminal (with there be a + on it)? Will I need to solder or is attached by a screw?
I'm wondering why I would not replace the condenser in its current location? Is it a bitch to remove?