I have followed every step of the Fix a Leaky Bing wiki entry and read the service manual and everything but I’m still having a lot of trouble. My 14mm Bing will only not leak if the float level is set to this crazy angle. Also attached is a picture of my extremely polished float seat. Everything you can replace has been replaced- gasket, float, float needle, float pin. It’s still leaking, what is going on???
If the carb does it's job , who cares what the float angle is ?
> P D Wrote:
> -------------------------------------------------------
> If the carb does it's job , who cares what the float angle is ?
So you’re saying it’d be okay to have the gas level in the float bowl possibly lower than it’s supposed to be, perform plug chops, then jet accordingly?
> Drake Abrahamsson Wrote:
> -------------------------------------------------------
> > P D Wrote:
>
> > -------------------------------------------------------
>
> > If the carb does it's job , who cares what the float angle is ?
>
> So you’re saying it’d be okay to have the gas level in the float bowl
> possibly lower than it’s supposed to be, perform plug chops, then jet
> accordingly?
Exactly .
Want to post in this forum? We'd love to have you join the discussion, but first: