I got this "Cdi stator" (power, trigger and ground outputs)
(I hear these za50 ones are terrible and I got the wrong one. )
to replace the original (only power wire output for ignition)
I would like to try and make it work still.
The only cdi boxes I have are 2 wire and do not have a trigger input.
Obviously the best solution is to just buy a box...
otherwise I should have bought this.
Do you think I could some how bypass or ground the hall effect sensor or even take it out? (and make it work)
Maybe I could use an auto relay and use the trigger coil?
I read a few threads. and the wiki.
(no pictures here)
Maybe I can wire it through a trailtech rectifier or something for some reason idk. I have electrical components if anyone can suggest an easy circuit.
Anyways, it will probably be burnt out soon.
I have been using a parmakit cdi/ coil, but I have been using a switch to disconnect the ground wire instead of using the switch to ground the power wire, which I hear can damage them sometimes. I might take it apart soon even though I still get spark out of it.