Re: From my stator wattage step down, fuses "how to"

D D /
This single post is part of a larger thread. Start from the top or view this post in context.

I have a ice bear vintage conversion to 100cc A9 cam setup I have only ran for 10 minutes

I have a kymco people 50 2t with similar ignition .. i want to upgrade mod

I have a third old moped I'm putting money into and it runs transitorized

Conversion is what i want

So point a is watts voltage for cdi and coil

But to use better fuses for reliability

I would use I'm guessing a 5 amp 12.volton my ac mopeds

Reg/ret doesn't act as a good fuze

Its gy6 stuff on my test one

But if I run a direct power to my cdi

Off the regulator rectifier

I would need what fuze set to protect it extra... my kymco uses DC

In the future all my mods have to do with upgrading the cheap crap out for reliability... my top slide carb on my resto mod is listed for $450 mikuna

I'm willing to do the work and pay to keep my bikes nice

This single post is part of a larger thread. Start from the top or view this post in context.

Want to post in this forum? We'd love to have you join the discussion, but first:

Login or Create Account