Re: Pedals spin, won't engage pulley

J D /
This single post is part of a larger thread. Start from the top or view this post in context.

Will do on the hub pic, thanks!

Regarding the drill start, it was an easy fix. Switched from low to hi rpm on the drill and cranked the drill's clutch a couple of clicks south of full-on drill mode. Fired up, started pulling gas through the carb and ran her for about 10 minutes. Then shit started popping off and vibrating loose all over the place. I think that the drill in low revs was holding the engine back. No issues when I ran it faster.

She runs again. Thanks for all the knowledge. I feel like a total idiot for not realizing how the drive train actually was supposed to be working. Glad smarter folks chimed in.

This single post is part of a larger thread. Start from the top or view this post in context.

Want to post in this forum? We'd love to have you join the discussion, but first:

Login or Create Account