I call upon the power of the Guru universe to help this possible brainfart...
HELP ME FIX THIS IN TIME BEFORE TITS AND KITS AND GITS SHITS RIDE...please and thank you
the bike has
polini 4p reeds
This bike ran and ran and ran well. Its a push start, and i had to push real fast, and had to have the clutch cable set to very hard, so push fast pull choke hard.
I took a few things apart and made a few changes. now I don't have a working ped.
when i push now, and look at the hpi while holding the clutch, it really doesn't spin much. I've tried to tighten and loosen clutch cable giving different grab strengths but to no avail. If i hold lightly and push slow, it turns quite a bit, but as soon as i run and hop on the spinning becomes intermittent (even at different clutch cable tightness')?
When i push and pull clutch, it just slows to a stop, im not even really getting glug glugs glugs.
I counter checked to make sure im not crazy against other mopeds, and when holding the clutch and pushing/pedaling the flywheel/ or spinning mass was spinning consistently
bike has compression, i took the head off and made sure the piston/ rings weren't broke. all good there
I took the phbg off, all clean. After trying a few pushstarts, the inside of the intake is all wet.
I drained oil, and refilled to make sure it was fresh and had correct levels.
bike has spark. when i hold the plug to the side of the head and can see little sparks.
as for the hpi, when I've changed the setting btdc. however its a range of 2mm btdc to 4 btdc. runs at about three, and that's where i had it when everything was reliable.
help me trouble shoot please!
I really want to think this thing is have a clutch issue but I don't understand how or what.