Puch Maxi for sale
E50 engine, stock crank with new bearings and seals (a year ago)
DMP 70cc kit (light porting on the piston windows and transfers),
Milled Stock head to match diameter IIRC,
Wide Smooth Transfer Case Match,
Small custom expansion chamber,
14.2-14.2 SHA drilled carb,
Side shot Minarelli intake also widened to 15mm,
Two shoe Barely tuned ( turned the screws is all) ,
Hardwired with Points, and somehow the brightest 6V lights I have ever seen. (head and taillight both working fine)
Sweet purple Pedal Chain!!!!!!!
Runs 18-45 gearing hits 37.5mph according to my phone; could use a better pipe and a bigger carb to hit higher speeds.
Gazelles and new tubes hold air with great tread!!!,
Wide spoke wheels,
Single seat (shaved and recovered),
Homemade low rise/euro bars,
Runs well, low idle and putts out at traffic lights sometimes. (probably could do a better tuning job than i did) When I had a "Ricky Bobby" homoett knockoff on it and a 19mm PHBG i went 50+ on this cylinder before I upgraded to a METRA 80
This is a ped I built to be very reliable and safe. It was my Wife's moped and I always tightened the cables, checked the wheel bearings for play, put new steering stem bearings (although it still has some play in it), and whatnot. It has always started for me and I have been using it around town while building my motor. Fun great beginner moped with easy speed upgrade potential.
Pick up in Wilmington, anytime especially at the WLR rally. or pay now pickup then whatever. I will hang on to it for a few weeks if that helps. Will NOT Ship or PART!!!!!
Email PM or Post with questions not related to the price and what you think it is worth and what you paid two years ago or what you think i paid for it in parts or how cheaply you built a faster bike or how common Maxis are ect..............