120 shipped. hydro-statically cleaned before they are case bored on a Bridgeport mill, port matched, however not completely port-matched, so that you can get a good seal without welding material to the case. I can do a lot of stuff but I can't tig. check the pic. I'll install a clutch cover is you want for ten bucks. I have two of these. I'm interested in anything puch, kits, pipes, controls, headlights, almost anything puch I'll look at for tradings
get me
benkrenke(at)yahoo(dot)com
bump for ben.
i bought a complete gila e50 from him, GREAT motor and shipped super fast.
Mmmm nice POV shot Ben!
I also have a complete gila E50 never been run W/aluminum stuffed crank, 5bills shipped OBO
What is included for 500?
Can you explain exactly what went into these cases?
they are dip cleaned in a hydrostatic cleaning machine, they are case bored on a Bridgeport mill, the transfers are forted and polished awaiting your gila lovin'. anything you need to do to cases to build a gila has been done. One set may be spoken for on the straight-up up swap tip werd? word.
new aluminum stuffed crank, new bearings & seals, un-ran gila kit w/matching head, new intake, new reeds, and hokey I got you.
For $500 they better be V-Force?
2 shoe or 3 shoe? paz springs?
Why should $500 be with v force reeds? A gila kit is 200, a crank is $100+ bearings and seals are $40 and figure the cases are worth $120 to be prepped the right way for a gila. That's $460 before shipping costs right there, not to mention its already assembled, and you get the counter shaft and any other hardware for free? People never want to pay fair prices for anything!
hey thanks broseph The Ohio guys and I have a running dialoge over what stuff does cost what stuff should cost it's in good fun. the clutch in the complete motor is the 2 shoe lightened clutch I've been working on, and V-force reeds are over-rated.
emailed.
$500 ain't bad I'm just curious. If I were interested in building a superblasting Puch and had no bottom end I'd maybe consider it. :)
All love, I've got strong interest in the complete motor, someone also offered 250 to make the last set of cases a complete bottom end. I could do the too. I have a metra crank I could build it with. But one set of just cases is gone, for puch tradings
second set of cases is spoken for. Complete engine (sans ignition&carb) brand new 450 shipped. has light weight 2 shoe clutch, designed for longer life.
vforce is the shit. i havent tried the top 8 petal but that vforce throttle response is crazy go butts.
ben hooked me up with my gila cases and they were clean as fuck.
Dip them in butter.
everything I had for sale is gone prompting me to disappoint a few cat which the prompted me to break down 3 bottom-ends and get them sent out. I should have them for sale in about 2 weeks
Willing to sale the metra crank?
I feel bad for those who dont have access to a machine shop...or even a drill with a paddle wheel bit...
I just got mine..
I will post pic.
sweet stuff right here..
don't buy that engine, if moonshiner touched it it's probably cursed.
<3<3<3<3 U krenke
luv U krenke
shit sun that's prolly your engine first
Want to post in this forum? We'd love to have you join the discussion, but first: