Money, projects, time, space, don't have I... you want?
If you run this setup through 1977's engine build form it's well over $1100 (granted I didn't spend that much on it, because I did all of the work myself (and good work I might add :)
This engine is too fast for my lead fist, as I've been pulled over on it over 3 times... ugh, so I took it off as a safety measure, now it's just sitting there and laughing at me.
What you get
Case matched mid/deep
"Stuffed racing crank":http://www.treatland.tv/puch-E50-super-stuffy-crankshaft-party-p/puch-super-stuffy-party.htm
Stock 3 Shoe Clutch w/ korado springs
Athena/MB5 19mm modded intake fits in a maxi or magnum to the left
Korado 2 big 12v coil electronics, with 500miles new points and HT coil break> kick stand + spring!
_I've always run with a good filter, even though this doesn't come with one.
with 18-36 and when I had the 24 mikuni and 8P on it GPSed at 66. and with the 19 it's not much slower tops, just alot better low end._
~500 miles on it No scuffs!
Pickup is nice, but will ship
call me (540)-470-0619
1st come, bla bla bla
A bit dirty, but that's how we roll... so suck it :)