Fresh off the laser: ZA50 case gaskets....get them while there hot, since its winter project time...$10 shipped!
(Email me for a paypal transaction)
FS Laser Cut ZA50 Case Gaskets
Re: FS Laser Cut ZA50 Case Gaskets
emailed
Re: FS Laser Cut ZA50 Case Gaskets
how much are available??
Re: FS Laser Cut ZA50 Case Gaskets
As many as you want. And just so you know they are cut from .012 thick paper the exact thickness of the nos gasket that he copyied. Because it is not "gasket paper" You will want to put a very very very thin smear of silicone gasket sealant on both sides of the gasket when doing final assembly. I have built two motors with these one is a metra 80 and the other is a gilardoni, and have had zero problems.
Re: FS Laser Cut ZA50 Case Gaskets
Way to go!!!
Re: FS Laser Cut ZA50 Case Gaskets
I have received inquiries, but I have not received any paypal confirmations.....I can send these out tomorrow, if I get confirmation tonight. Thanks army!
Also....I will be cutting .008 ZA50 gaskets next week, if you are interested.
Re: FS Laser Cut ZA50 Case Gaskets
bump for the weekend....
Re: FS Laser Cut ZA50 Case Gaskets
Paypal sent. Thank you
Bump for the ZA50s
Re: FS Laser Cut ZA50 Case Gaskets
sir
you ought to cut a boatload of these.
people will need these for the next 20 years at least.
Re: FS Laser Cut ZA50 Case Gaskets
consider it done
Re: FS Laser Cut ZA50 Case Gaskets
This just in.....the .008 in za50 case gaskets are now available, just let me know whatcha need!
Re: FS Laser Cut ZA50 Case Gaskets
bump
« Go to Topics — end of thread
Want to post in this forum? We'd love to have you join the discussion, but first: