This engine is ready to bolt up and go! Match this up with that shiny new carb and exhaust you've been stashing away for a rainy (sunny) day!
Stats and Mods:
1978 e50 bottom end
#22 Hi-Torque cylinder/head/piston from 1985 Puch Maxi
New bearings and seals
Tuned clutch (tightened in springs one full turn)
Cleaned points and set point gap
Advanced ignition timing to 2mm before top dead center
Ramped intake port for larger intake manifold and carburetor (15mm or 16mm would be ideal)
Cleaned up and lightly polished exhaust port
Completely rebuilt and cleaned.
I tested this build for a few miles on a Puch Magnum with a Proma GP exhaust and a 15mm Dellorto carb/intake. This engine had lots of torque with that setup and was asking for some tall gearing.
Comes complete as shown in last picture with coil and Maxi-length kickstand
Originally owned by legendary TBS party dude Mr. Sims for +2 good vibes!
Completely rebuilt during the last full moon for +2 magic spells!
Asking $200 shipped to your door.
Opened-up Intake Port
Cleaned Exhaust Port
Comes like this with coil and Maxi-length kickstand.