WTB Puch 20tooth front sprocket

Im looking for a puch front sprocket. It must be 20tooth. Anyone have one they want to sell?

Re: WTB Puch 20tooth front sprocket

wasn't your first post enough?

https://www.mopedarmy.com/forums/discuss/2/97359/97359/

i love how some dude finds a rare part, and suddenly theres sheer madness of other people looking for the same part

stick with a low end gear ratio, the rpms are much better

Re: WTB Puch 20tooth front sprocket

my town has a lot of flat land and i want all top end expecially with my speed kit

i all ready have the 18 but would rather have the 20.

Re: WTB Puch 20tooth front sprocket

There is absolutly no way your stock engine can pull a 18-36 ratio; the acceleration is no doubt extremely lagging, and your engine can't even rev all the way to top rpm with that kind of gear ratio. With an 80cc kit, you could run that kind of ratio, but you'll still mostly at a loss (no bottom end, or midrange power), especially with the 1-speed transmission. and as Dakota said in the other post, you'll have to grind the case for a 20 tooth sprocket to fit.

Re: WTB Puch 20tooth front sprocket

The stock motor does rev up even with a 360lb kid on it. It just takes forever. I am getting the 80cc kit.

Re: WTB Puch 20tooth front sprocket

to run that gear (20t) you should have a ZA-50

Re: WTB Puch 20tooth front sprocket

ಠ_ಠ Jon Folks ಠ_ಠ /

You are better off making your own.

Re: WTB Puch 20tooth front sprocket

how would i make my own?

« Go to Topic — end of thread

Want to reply to this thread?

We'd love to have you join the discussion, but first you'll need to login (or create an account).