Re: Troubleshooting and Tune-Up

Fred /
This single post is part of a larger thread. Start from the top or view this post in context.

Well... I have to tell you Ron.. as simple as those instructions are... I do believe that a lot of people are overwelmed by them anyway.

And the more details you put in the more likely they are to stop reading.

Many young people want 5 word answers to everything.

I have tried to help a few here and it was obvious that they didn't read the answer.

The point cam location and the point of not using too much grease are both hard to get across

I have never personally had a float that didn't float.

Since the point gap sets the timing, I would rather tell them to get the timing right...and let the gap fall where it may.

However.. for ease of simplicity and understanding, telling them to set the point gap may be clearer ...(and forget the timing)

I've never seen a jet smaller than a bristle....but. maybe ??

Wire brush bristles are .010" to .015" dia. (that I found)

I agree with the wet and dry paper (which is what I use, but i didn't think to say it)

I agree with the vacuum petcock and high pressure air.

Have to delete that.

This single post is part of a larger thread. Start from the top or view this post in context.
Subject Written By Posted
  Cant start moped =(Topic by: Joey Joey 01/24/01 05:44PM
  Troubleshooting and Tune-UpRe: Fred Fred 01/24/01 09:58PM
  Re: Troubleshooting and Tune-UpRe: Joey Joey 01/24/01 11:17PM
  Re: Troubleshooting and Tune-UpRe: Ron Brown Ron Brown 01/25/01 12:56AM
  Re: Troubleshooting and Tune-UpRe: Fred Fred 01/25/01 10:24PM
  Re: Troubleshooting and Tune-UpRe: Ron Brown Ron Brown 01/26/01 10:52AM

Want to post in this forum? We'd love to have you join the discussion, but first:

Login or Create Account