STL Files

Ryan Rappoport /

Mar 07, 2022 04:48PM

I am going to start 3d scanning and reproducing plastic parts from mopeds.

so far, all the parts I have that I will scan are the following. Honda nc50 footpeg covers, headlight bucket/ring, carb cover and oil pump cover.

Suzuki fa50 headlight bucket,

suzuki fz50 headlight bucket, oil cover plastics, and airbag.

Yamaha qt50 headlight bucket/ring, footpeg covers, side covers and battery box.

I would love to hear what all parts y'all would like to have made. the parts will be 3d printed so it would be best if they did not get covered in gas or oil.

Re: STL Files

P D /

pdcomm

Mar 07, 2022 05:06PM

In case you haven't seen this :

https://www.mopedarmy.com/wiki/3D_Printed_Parts

Re: STL Files

Ryan Rappoport /

gator7656 OP

Mar 07, 2022 05:20PM

I have not seen that. Thank you!

Re: STL Files

Ian MacKenzie /

salem2019

Mar 07, 2022 05:26PM

Hi Ryan. I’m going to end up not using my qt50 headlight. If you cover shipping I’d gladly send it to you along with anything I might be able to send to you with it? I also have the battery box by not the latch. And the front grill piece (edited)

Re: STL Files

Pushrod Fifty /

supercub

Mar 09, 2022 12:34PM

I bet the scans are pretty accurate with today's technology. Is anyone printing in carbon fiber commercially? It would be a blast to design my own moped frame in solidworks and get it printed in CF. I have printed a sample part in PC and let it soak in gas for a week, no affect noticed in the material. A translucent tank in PC would look awesome against the CF.