MOPED ARMY

Looks like a winner . ;)

ya id buy them too!

It would be modern day school boy thing to do! Any surface in my old schools had a penis drawn on it, but it is difficult nowadays with tablets and interactive whiteboards.

Yes, I can do black.

I rubbed one out this morning. I'll have to see how well it prints when I get home tonight.

Still needs a little fine tuning...

You're a goddamn hero, sir!

I laughed my ass off at that! My wife wasn’t nearly as impressed. 🤷‍♂️

HOW MUCH TAKE MY MONEY ALREADY!

Need a velocity stack to go with it?

A Vaglocity Stack. I see

LMFAO

Something a bit more practical. SHA to stock Maxi air box.

And damn this bike has been sitting too long. That chain is drier than the velocity stack I posted. (edited)

Ever thought of doing Honda Hobbit and Camino plastic parts? I hear they are in high demand. Fenders, carb covers, light covers etc.....Or if you can use a plastic that is Gas Proof you could make Gas tanks?

And you sent me down a rabbit hole…. Seems what most people have had success with is 3D printing a mold for fiberglass, but then you have the issues with fiberglass tanks.

TPU is a common and fairly easy to print filament but you still have the issue with layer lines seeping. Not too many adhesives or coatings like to stick to TPU. It’s good for fiberglass molds for that reason.

The one readily available solvent that has an effect on TPU is DMSO. I’ve used acetone to “polish” abs prints to make flower pots that will hold water. Next time I’m at the farm store I’m gonna grab some DMSO and see how it does on a TPU print.

TPU is rather flexible, it has the consistency of a hard rubber, I don’t know how practical it would be for a free standing tank but it could be cool with polished metal supports wrapped around it. Use a translucent TPU and mount a bright LED under your gas cap and you won’t need a fuel gauge. Plus it’ll be obvious if you forgot to premix.

Damn. I have an unopened 1kg roll of clear TPU. Something may be getting an auxiliary tank.

If anyone wants has a top tank they want a cool tank for get at with me with a few spoils of filament. My max print size is a 300x300x310. and if I ever stop being lazy and tune it properly, moped excuses, Ive got a

Duex machine so two color prints or embedded reinforcements of a harder material for mounting points. For a fuel

Tank probably want to take advantage of the dual extruders to print all the support surfaces in water soluble filament to make them easier to remove. Then things like antislosh flaps, dividing one corner out for reserve, ensuring that there’s a clean tube for the cocaine and money to drop into. Peoples all about smoking diesel, I ain’t dying to smoke no 2% mix, hell, by kits ask for 3%

TLDR: I’m gonna make a small tank out of

TPU then rub it down with farmer snake oil and see how it holds up. I already sent one Maxi to Valhalla, I ain’t skeered to do it again.