I did a continuity test from the terminal block to the lightbulb and it checked out fine. I'll take your advice and check the voltage too. I never thought to do that.
Thanks. Now I have another route to try.
If I have to pull off the flywheel, I can make a bracket for my puller with no problem. I noticed that there are four smaller (5mm) threaded holes around the flywheel. Is this where I would mount the puller bracket. I REALLY don't want to bend or break anything here!!!
I have also thought about getting the light coils rewound to convert to a 12V system. I know a place nearby that can do this for me. Does this sound wise?