Replaceing puch fork springs
Anybody done this? I was thinking about doing this instead buying EBR's because of their bad reviews. The puch shop manual has the wire diameter at 3mm and the overall length at 184mm, but no outside diameter, or compression length, ect. Would like to beef up the springs a little also. Anybody have any ideas on what material to make them out of. There are a lot of custom spring shops out there.
| Subject | Written By | Posted |
|---|---|---|
Replaceing puch fork springs
|
||
 
Re: Replaceing puch fork springs
|
||
Re: Replaceing puch fork springs
|
Sorry, you must log in before posting to this forum.