WTT custimized g3 for magnum

• Author: electricave (---.try.wideopenwest.com)
• Verified User: electricave
• Date Posted: 04-30-08 18:18

I have a sachs g3 project that is almost complete that i would like to trade for a magnum (in or around ohio)
G3 info:

-Rebuilt 505/1d engine, completly taken a part and cleaned. Decarbonized, All new gaskets and seals, head slightly honed, new rings, , used original intake but mounted it forward on the bike (ports where dremmeled out to match, also had to cut one colling fin out a little bit) completly rebuilt 12mm puch bing, also has new plug and ignition wire.

-Gas tank is welded (so it has a normal thread-on cap, instead of the original crappy plastic-plug set-up) It uses a magnum cap. Welds just need to be grinded down and filled.
tank has rust inside, but nothing serieus, acid would clean it up fine.

-Clubman handlebars

-new tires and tubes

-front wheel bearings have been cleaned and re-packed.

-new rear sproket
– new points and condensor

-new tailight bulb

-tabs for the side-covers have been grinded off

-new non-restrictive header and bi-turbo exuast

-brakes have been deglazed and work fine

-started to paint it black & green, (I have the rest of the paint to finish job)